Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

水处理中微生物絮凝剂产生菌的选育及应用

综述了微生物絮凝剂产生菌筛选和培育方面的研究进展,介绍了微生物絮凝剂在给水和饮用水、乳化液的油水分离、污水处理等领域的应用,以及廉价培养基的探索实践。提出针对影响微生物絮凝剂产生菌生长代谢的环境条件开展深入研究,同时寻找或设计廉价培养基,降低生产成本,推动其工业化应用。     

煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

Nest-building by crested tit Parus cristatus males: an analysis of costs and benefits

In a population of crested tits in Belgium, one out of three breeding males participated in nest-building. Since variation in the amount of nest-building among 11 building males was low, analysis of male nest-building allowed a logistic regression design. The probability of building increased with male condition and for late nests. The effect of male condition decreased with date, and date was the only factor predicting nest-building for repeat broods. The effect of male condition on nest-building suggests that building entails important costs for males. Based on correlative data, we argue that building by males shortens the interval between the start of nest-building and the onset of egg-laying by about 5 days. Since clutch size, incubation and nestling time did not differ between early and late broods, male nest-building apparently affects fledging date. Since early fledgers (early dispersers) are more likely to settle in future winter flocks, building behaviour by crested tit males should be favoured by natural selection. So far, male nest-building in hole-breeding birds might have been overlooked due to the widespread use of artificial nest-boxes in behavioural studies.     

Degradation of polycyclic aromatic hydrocarbons by combined chemical pre-oxidation and bioremediation in creosote contaminated soil

The ability of pre-oxidation to overcome polycyclic aromatic hydrocarbons (PAH) recalcitrance to biodegradation was investigated in creosote contaminated soil. Sand and peat artificially spiked with creosote (quality WEI C) were used as model systems. Ozonation and Fenton-like treatment were proved to be feasible technologies for PAH degradation in soil. The efficiency of ozonation was strongly dependent on the water content of treated soil samples. The removal of PAH by Fenton-like treatment depended on the applied H2O2/soil weight ratio and ferrous ions addition. It was determined that the application of chemical oxidation in sand resulted in a higher PAH removal and required lower oxidant (ozone, hydrogen peroxide) doses. The enhancement of PAH biodegradability by different pre-treatment technologies also depended on the soil matrix. It was ascertained that combined chemical and biological treatment was more efficient in PAH elimination in creosote contaminated soil than either one alone. Thus, the combination of Fenton-like and the subsequent biological treatment resulted in the highest removal of PAH in creosote contaminated sand, and biodegradation with pre-ozonation was found to be the most effective technology for PAH elimination in peat.     

湖州市埭溪镇污水处理厂的工程设计

湖州市埭溪镇污水处理厂的设计规模，近期为2万m^2／d，远期为3万m^2／d，其污水处理工艺采用改良式A^2／O工艺，污泥处理工艺采用带式浓缩脱水一体机。文中着重介绍了工程设计参数、处理工艺流程及其设计特点。     

生态土壤渗滤系统启动周期研究

利用室内模拟试验装置,考察了4种生态土壤渗滤系统在0.1 m3/(m2·d)的水力负荷条件下对生活污水中TP、COD和NH3-N的去除效果及启动周期; 同时对整个系统及同类生态工艺启动周期的判断方法做了探讨.研究结果表明,生态土壤渗滤系统对TP、COD和NH3-N的启动周期分别为15～27 d、24～40 d和24～26 d; 土壤渗滤系统对TP的启动周期最短,对COD的启动周期最长; 处理系统启动周期的判断原则是综合考察系统对主要污染物各自的启动周期,以最长的作为系统启动周期.4组试验中,1#和2#系统的启动周期为40 d; 3#和4#的为24 d.     

用海泡石处理采油废水

用海泡石吸附法处理采油废水，考察了处理时间、海泡石加入量和采油废水pH对采油废水COD去除率的影响，并通过正交实验优化了采油废水处理工艺条件。通过正交实验得到的采油废水处理最佳工艺条件为：处理时间6h，粒径为150μm的海泡石加入量200g／L，采油废水pH9。在该条件下处理采油废水，COD去除率达到91％，处理后出水的COD为34．71mg／L，小于GB8978-1996（（污水综合排放标准》中的一级标准（60mg／L）。     

O3-BAC深度处理工艺中细菌群落时空分布及动态变化规律

为弄清饮用水O₃-BAC深度处理工艺过程中细菌群落的时空分布和动态变化规律,本研究以我国南方某O₃-BAC深度处理工艺水厂为研究对象,采用NovaSeq6000高通量测序技术对夏季和冬季各工艺单元出水及滤砂和活性炭生物膜等细菌群落进行解析.结果表明,出厂水pH、浊度、COD_Mn、菌落总数等指标均满足《生活饮用水卫生标准》（GB5749-2006）的要求.夏季细菌群落多样性明显高于冬季,活性炭生物膜的细菌群落多样性高于滤砂生物膜;混凝沉淀、臭氧化和消毒是影响细菌群落多样性的主要工艺单元.水样和生物膜样品绝对优势菌门均为变形菌门（Proteobacteria）,且主要菌门组成大体相同,但细菌群落门水平相对丰度存在一定的时空差异,属水平上差异则更为明显.此外,检测到的条件致病菌属主要包括芽孢杆菌属（Bacillus）、不动杆菌属（Acinetobacter）、假单胞菌属（Pseudomonas）和分支杆菌属（Mycobacterium）,且其所占核心微生物OTUs数目不受季节性影响.水温和生物可降解溶解性有机碳（BDOC）是显著影响细菌群落分布的主要水质参数.以上研究结果表明,O₃-BAC深度处理工艺过程中细菌群落具有时空变化特性,并可为饮用水微生物安全保障提供支撑.     

AMD铁絮体改性生物炭对重金属吸附机理研究 ——以Pb(II)为例

以酸性矿山废水生成的铁絮体和秸秆生物炭为原料,采用化学改性和紫外辐射联用技术制备改性生物炭,并通过正交试验确定最佳改性条件,同时利用FTIR、SEM和BET等方法对吸附材料的形貌特征、孔隙结构及其表面化学性质进行表征.结果表明,通过改性使吸附材料比表面积增大,吸附位点增多,在25℃、pH为7时,吸附材料改性后比表面积为295.71 m²·g^-1,对Pb（II）的拟合吸附量可达278 mg·g^-1.改性材料对Pb（II）的吸附过程符合Langmuir吸附等温线模型和准二级动力学模型,主要为单分子层吸附,受化学吸附控制.